The double skin on the GD bonnet was of good quality and looking at it in the daylight it was now spot on but hard to show in a picture. The M4 nut caps still needed a slight bit of silicone on each one t prevent them coming off on the road.
Sunday, 22 December 2013
Bonnet finishing
I had been waiting on a few packets arriving in the post, one of those was M4 nut caps to cover the nuts on the underside of the bonnet. The stainless nuts looked ok but just were not doing it for me and I wanted that area to loo a tad tidier.
The double skin on the GD bonnet was of good quality and looking at it in the daylight it was now spot on but hard to show in a picture. The M4 nut caps still needed a slight bit of silicone on each one t prevent them coming off on the road.
Caps on and a rubber lip across the joint where the mesh is bonded on helps the finish of this area.
The double skin on the GD bonnet was of good quality and looking at it in the daylight it was now spot on but hard to show in a picture. The M4 nut caps still needed a slight bit of silicone on each one t prevent them coming off on the road.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment